Logtag-recorders LogTag Analyzer Temperature Recorder Manuel d'utilisateur télécharger pdf (Page 32)

32 LogTag Analyzer User Guide (2.0)

Record readings so

that:

If this is selected, the logger stops logging when the number of

data points has been gathered and stored in memory that spans at

least the number of days specified below. When this option is

selected, the following two options will determine the number of

data points over the span of time that will be recorded.

Readings recorded will

span at least X days

If you know how long you want to record, the Configuration screen

will automatically set the number of readings to be collected at a

particular interval. This setting will only have an effect if the above

option "Record readings so that:" is selected.

Number of readings to

record X maximum is Y

This data box will display the calculated number of readings if you

select a time span and an interval. Alternatively, you can select the

number of readings desired, and the time span will be altered

based on the interval. If this is selected, the logger will stop logging

when the number of readings has been gathered and stored in

memory. "Y" represents the maximum number of readings the

LogTag can store, however with a selected interval and a selected

time span, you may not need to use all of the available data space.

This setting will only have an effect if the above option "Record

readings so that:" is selected.

Record a reading every

This determines how frequently the LogTag records the

environmental humidity and/or temperature into its internal

memory.

Begin recording after a

delay of X

Determines how long after the START MARK button on the LogTag

has been pressed that it will actually begin to record the

environment humidity and/or temperature. This feature is useful for

example, when the LogTag could falsely trigger an alert because

the environmental conditions it is being started in is quite different

to the environmental conditions to be monitored. If pre-start

logging is enabled, the LogTag will continue to record pre-start

readings during this delay.

Enable the OK (Green)

indicator

This determines whether or not the green light should function

while the LogTag is recording after being started.

Humidity / Temperature These tab controls will allow the humidity and temperature alert

conditions to be configured independently. These tab controls will

only appear when configuring a LogTag that has a humidity and a

temperature sensor. If the LogTag has only one sensor then the

following alert conditions will apply to that sensor.

Configure requires a

password

This feature allows the user to define a password that must be

provided (see "Restricted Access Requirements" on page 28) to

configure the LogTag next time. If this option is enabled and the

password changes, the user will be required to verify the new

password (see "Verify Access Password" on page 42) when the

wizard progresses to the next step. Passwords are case sensitive

and therefore the passwords "Bob" and "bob", for example, are

different.

Download requires a

password

If this option is enabled, the LogTag's recorded data can only be

downloaded after entering the correct password.

Note: Only one password can be provided for each LogTag. The

same password applies to the Configure and Download actions.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 171 172

Commentaires sur ces manuels

Pas de commentaire

Logtag-recorders LogTag Analyzer Temperature Recorder Manuel d'utilisateur Page 32

Commentaires sur ces manuels